Solenoid Valve for Snap-On® MIG Welders YA-212A, MM250SL, FM140A & 140SL MIGWELD 140 Features a standard center mounting

Features a standard center mounting hole measuring 5/8" in diameter

Also works with other plasma cutters using an S54 Plasma Cutting Torch

18 Series Water-Cooled Alumina Standard Consumables

TIG contractor kit for the Miller® Multimatic 215

Please contact us if the mentioned guns are not the one you are looking for and we can verify what graphite liner will work for you 847-357-0700

Solenoid Valve for Snap-On® MIG Welders YA-212A, MM250SL, FM140A & 140SL MIGWELD 140 Features a standard center mountingIf your gas solenoid valve is not working, it could be the valve or it could be the Circuit Board. Easiest way to test is to use a voltmeter and measure the voltage going to the valve with the trigger pulled. If you have 24 volts at the valve with the trigger pulled and you don't have gas then its probably the valve. If you don't have 24 volts, then its probably the the PCB. This gas solenoid valve fits ONLY the following Snap On Welders: FM140A